Rhinestone Template Material

I have the Material you need for cutting Templates.

I many different kinds of Rhinestone Template Material Grab what you like.

I have a few different sizes so pick what size you need

I use the same settings for all my materials, I do not adjust my pressure or my blade.

I cut with a 60 Degree Blade

I cut all my Template materials on one of my weeding Mats

Peel the backer off

Stick carefully to the mat (Shiney side) make sure to leave no air bubbles under the Rhinestone Template Material

Always put a weeding box around the design so you can lift it slowly and easily from one corner,, work your way around to loosen the edges if it is a large design

Go very slow as not to distort the Rhinestone Template.

Do not let the cut Rhinestone Template sit on the Weeding Mat , Lift off the template right away so the Glue does not adhere to the mat.

Also clean as soon as possible too.

I use my Rhinestone scoop to Clean my mats, I take a piece of scrap Template material and  wrap around the end of the  scoop to cover all edges of metal that could be sharp and then scrape the mat very easily clean.

I advise to keep one mat for Green rubber Material and one for other Rhinestone material.

Only use one side to stick the material to , to run through your cutter.

Never run the side you stuck your Rhinestone template material to , through your Cutter. The glue could damage your rollers. Always stick the Rhinestone template material to the same side.

If you want a size I dont have please send me a email, I will try to get it for you